Yokogawa Integral Oxygen Analyzer ZR202 - Manual (Page 84)

IM 11M12A01-05E 7-11
7. Startup
7.6 Setting Display Item
Display items are those items that are displayed on the basic panel display. Parameter
code A00 or F08 is used to set the display items as shown in the table below. If the
humidity analyzer /HS option was specified at the time of purchase, the equipment is a
humidity analyzer. For other than the above, the equipment is set to oxygen concentra-
tion at the factory before shipment. If mix ratio is to be measured, change the existing
setting as follows.
Additionally, when humidity analyzer is selected in the Detector Type Setting in the
previous section, the display item will be humidity if data initialization is performed.
Table 7.4 Display Items
T7.4.EPS
Values set with Items displayed on the basic panel display
A00 or F08
0
Indicates the oxygen concentration.
1 Indicates the humidity.
2 Indicates the mix ratio.
3 Displays an item for the current output. If the output damping
has been set for the current output, values involving the output
damping are displayed.
Table 7.5 Display Item Setting Procedure
T7601.EPS
Display after the password has been entered.
Touch the [ ] key to move the position of the digit that is
flashing to the right.
Touch the [ ] key to change the parameter code to 0. The
number will change from 1 to 2 to 3 9 and back to 0.
Touch the [ENT] key to display the current set value.
Set the mix ratio. Touch the [ENT] key to change the
number to 2.
Touch the [ENT] key. The number 2 will be flashing.
Touch the [ENT] key again to stop flashing.
Touch the [ENT] key to return to the parameter code
selection display.
Touch the [ ] and [ENT] keys simultaneously to return to
the basic panel display on which the mix ratio appears.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
The symbol ( ) indicates that the corresponding keys are being touched, and the light
characters indicate flashing.
A 01
A0 1
A0 0
0
2
2
2
A 00
0.000
Switch operation Display Description
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT