3 setting the moving average (dot model), 3 setting the moving average (dot model) -3, 3 settng the movng average (dot model) – Yokogawa µR10000 User Manual
Page 117: App index
6-3
IM 04P01B01-01E
Setup
Operat
ons
for
Conven
ent
Funct
ons
(Sett
ng
Mode)
1
2
3
4
5
6
7
8
9
10
11
12
App
Index
6.3 Settng the Movng Average (Dot Model)
This section explains the details of setting the moving average function on measurement
channels on the dot model.
Procedure
1.
Hold down the
MENU
key for 3 seconds to enter Setting mode.
2.
Press the
key or
SHIFT +
key to select
Aux and then press the key.
3.
Press the
key or
SHIFT +
key to select
Movng_AVE and then press the
key.
4.
Set each item and press the key.
Use the
key or
SHIFT +
key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the
ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
5.
When the
Settng complete screen appears, do either of the following:
Press the key to set other channels.
If you are done, press the
ESC key.
6.
Hold down the
MENU
key for 3 seconds to return to Operation mode.
Set the channel range.
Set the number of samples of the
moving average. Moving average is
not performed when Off is selected.
The new setting takes effect.
ESC/?
First channel Last channel
Set=Aux
Aux=Moving_AVE
CH=01-01
No.of samples=Off
01-01 Channel
Setting complete
Explanaton
The Number of Samples of Movng Average
The number of samples can be set to a integer between 2 and 16. Select Off when not
using the moving average function.
<Related Topcs> Enabling the moving average function: Section 7.11