Yokogawa µR10000 User Manual
Page 166
7-29
IM 04P01B01-01E
Setup
Operat
ons
for
Chang
ng/Add
ng
Funct
ons
(Bas
c
Sett
ng
Mode)
1
2
3
4
5
6
7
8
9
10
11
12
App
Index
Explanaton
Remote No.
The remote control terminal numbers are from 1 to 5.
Functon to Be Assgned
Record On/Off: Starts/stops recording.
Alarm ACK: Executes alarm output release.
Time adjust: Adjusts the internal clock to the nearest hour.
Manual print: Executes manual printout.
Message #: Prints message # (where # is a value between 1 and 5).
Chart speed: Changes the chart speed.
Math start/stop: Starts/stops the computation on the computation function (/M1
option).
Math reset: Resets the computed result of the computation function (/M1 option).
Priority R_RCD: Starts/stops recording (/BT1 option).
BatchCMT switch: Start printout and Start printout 2, End printout and End printout 2
switches according to the status of the “BatchCMT switch” signal
during the rising or falling of the “Record On/Off” or “Priority R_RCD”
signal (/BT1 option).
None: No function is assigned.
Note
When you select “Priority R_RCD” and start recording remotely, you cannot stop recording
using key operation or communications.
<Related Topcs> Setting the secondary chart speed: Section 6.9
7.18 Assgnng Functons to the Remote Control Input Termnals (/R1 Opton)