RIKON Power Tools 50-110 User Manual

Page 5

Advertising
background image

Fig. 01

Fig. 02

5

Assembly

Securing Sander Base Assembly to
Workbench

The Sander Base must be secured before

using. Attach a large C-Clamp to each side of

the sander and the workbench. Or, permanently

mount following the instructions below:

1. Place the sander on the workbench in its

proper operating position.

2. Place a pencil through the mountong holes of

the sander base (42) and mark the hole locations

on workbench.

3. Remove sander and drill two 3/8 inch holes

through the workbench.

4. Align sander base over holes and secure using

two 5/16 inch screws (or larger) and hex nuts.

(See Fig. 01)

Mounting Sanding Disc and Guard

1. Locate sanding disc (27) and peel backing off

disc.

2. Align perimeter of sanding disc over plate.

When aligned, press disc firmly onto disc.

3. Position disc guard (32) onto lower portion of

sanding disc so that the mounting holes align.

4. Using a Phillips screwdriver, fasten two pan

head screws (found in parts bag) through disc

guard. (See Fig. 02)

Installing the Work Support

1. Place Work Support (9) over sanding belt.

2. Place the hex screw (6) through the lock

washer and flat washer (7 and 8) and fasten.

(See Fig. 03)

Fig. 03

Advertising