RIKON Power Tools 50-110 User Manual

Page 6

Advertising
background image

6

Fig. 05

Installing the Table Assembly

1. Locate the Table Support (36) and mounting

hex screws (6) and washers (7 and 8).

2. Stand Table (35) on its side, align holes.

3. Fasten Table Support to Table. Do not over

tighten screws.

4. Position Table Support (36) in corresponding

holes on side of base. (See Fig. 04)

5. Place Washer (8) on Knob (1) shaft and insert

through slot into threaded holes in base.

6. Loosen the three Hex screws (6) and adjust

table so that there is a maximum of 1/16 inch

space between the sanding disc and the table.

Tighten screws. (See Fig. 05)

Fig. 04

Advertising