RIKON Power Tools 50-110 User Manual

Page 7

Advertising
background image

7

Leveling Table Assembly

1. Place a combination square on the Table (35)

so that it also touches the sanding Disc (27).

(See Fig. 08)

If the Table is 90 degrees to the Disc, no

adjustments are needed.

2. If the Table is not 90 degrees with the Disc,

loosen the table lock Knob (1) and tilt the Table

until the square is flush with the Disc.

3. Retighten the Knob to secure the table.

4. Attach the scale label (37) to the “0” degrees

mark on the dust guard (34).

Installing and Adjusting the Sanding Belt

*Belt table must be in the vertical position.

1. Move Tension Lever (66) to the right to release

the Sanding Belt (10) tension. (See Fig. 09)

2. Place the Sanding Belt over the Drive and Idler

Drums (13 and 65). (See Fig. 10)

Make sure that the inside direction arrows point

down, towards the Drive Drum (13). (See Fig. 11)

3. Center Belt on both drums.

4. Slide Tension Lever (66) to the left to tighten

belt

tension.

5. Tighten Hex Socket Screw (56) when Bed (4)

is

in desired working position.

6. Plug the Power Cord (38) into the wall outlet.

Turn the power Locking Switch (22) On, and the

off

while viewing the belt movement. If the belt looks

like it was going to slide off either drum, the belt

racking needs to be adjusted (described in the

next

step).

7. If the Sanding Belt (10) moves towards the

Fig. 08

Fig. 09

Fig. 10

Fig. 11

Advertising