KROHNE UFM 600T EN - Manual (Page 71)

3.5.8 DEFAULT SET
If this function is used all parameters will be reprogrammed
to default settings (see Appendix 5).
(NOTE: factory settings are not affected by this function)
NOTE: The Date, Time and Location data will be lost, too !!
This function should only be used to restart programming if
the cause of a PARAMERROR can not be found; it offers a
start with no error messages as far as the parameters are
concerned.
3.5.9 SOFTW. V. NR.
This function can be entered to view the number of the cur-
rent software version.
No action can be taken here.
68
ALTOSONIC
Programming mode
UFM 600 T