KROHNE Summit 8800 Vol 1 - Manual (Page 36)

36 www.krohne.com 08/2013 - MA SUMMIT 8800 Vol1 R02 en
SUMMIT 8800 HARDWARE DETAILS 05
OPEN The SUMMIT 8800 is fully open and changes can be made without restrictions.
However, user passwords are required.
PARTIAL In this mode the front panel Edit mode can be accessed with the proper user pass-
word, but calibration data cannot be changed.
New application information cannot be uploaded or downloaded. The existing configu-
ration can be downloaded, changed and uploaded again. The type of changes allowed
can be defined using the configurator Software and will typically be non-critical con-
figuration data, parameters and values.
FULL Connection is possible and applications can be uploaded, but cannot be downloaded
to and from the SUMMIT 8800 as it is in Read only mode. Change in parameters, val-
ues or any other data is not possible. Configuration data cannot be changed with the
GUI software. Edit menu cannot be accessed. Calibration data cannot be changed.
Alarms and audit data cannot be cleared.
It is possible to define in the configuration in which mode alarms can be acknowledged or
cleared and audit data can be cleared.
The settings of the Security mode, can be found on the System information page:
Figure 20 System information screen
5 .2 .3 SD Card
The SUMMIT 8800 contains a replaceable SD memory card on the Auxiliary board, this card can
be used to store Audit and Data Log Information. It can be replaced at any time by withdraw-
ing from the connector on the rear panel and a new card can be inserted. When a new card is
inserted it is automatically detected. Depending upon its formatting and use, possible messages
and instructions will appear on the main screen.
Follow the on-screen instructions, and the card should be prepared ready for use.
Once removed, a filled or partially filled card can have its data read using a standard PC card
reader and the supplied Windows software.
The SD can also be read whilst installed in the SUMMIT 8800 by using the configuration soft-
ware.