KROHNE BM 70 A_P EN - Manual (Page 83)

Installation and operating instructions BM 70 A/P Page: 83 11/00
Protocol 8.6.9
Purging device 6.1.7
Quality assurance 13
Reference conditions 5.1
Reference offset 8.6.6
Reflection 3.1, 8.6.1
Rel. Permittivity 6.3.2
Repeatability 5.3
Replacement of signal converter 2.3, 7.3
Returning the device Annex D
RS 485 4.1, 4.6, 8.6.9
Safety conductor 9.4
Safety lock 9.3
Safety, advice on Page 3, 6, 9.4
Setting, see Configuration
Shielding strip
6.1.8
Side vessels 6.1.2
Signal converter 7.6.1, 2.3, 7.4
Signal output 4, 5.8
Signal processing 2.2
Software history page 4
Spare parts Annex C
Spectrum 2.2, 8.6.12
Standards 12
Stilling well 3.3, 6.1.4, 6.1.2,
8.6.5
Storage temperature
6.2.5
Sunshade 6.1.9, 6.2.2
Supply scope Page 3
Supply voltage 4.3
Switching output 4.2, 7.8, 8.6.17
Tag name 8.6.10
Tank bottom offset 8.6.6
Tank bottom tracking 8.6.15
Tank fitting 6.1.3, 6.1.8
Tank height 3.2, 8.5, 8.6.2, 8.6.11
Tank type 8.6.16
Tank wall 6.1.2
Technical data 9.1, Annex A
Temperature 5.8, 6.2.2, 6.2.3, 6.2.4, 6.2.5,
6.3.4, 10.3
Temperature drift 5.8
Terminals 7.8
Terminating resistor 7.9
Test functions 8.7.1
Threshold 8.6.17
Time constant 5.5, 8.6.13
TN system 9.2
Tracking speed 8.6.13
Transient recovery time 5.5
Transmission angle 6.1.1
Transport Page 3
Turn-on characteristics 5.6
Type code Annex B
Units 8.6.1
Vessel, see Tank
Vibration endurance limit
6.2.9
Volume measurement 3.1, 8.5.2
Warranty Page 3
Wave-Guide 6.1.2, 6.1.5, 7.1
Wave-Stick 3.3, 6.1.3, 7.1, 7.2, 7.5
Weight 7.2