Hoyles Cig-Arrete Radio Com'd Flame/ Smoke Detector c/w Voice Alarm - Manual

WIRING CONNECTIONS
If you are using a power supply, then decide which product
will be the Master Unit of the system and connect a 6Vdc
power supply as shown opposite. This connection is continued
through to every device on the system to supply power. This
will normally be the CSA‐FSU installed outside the washroom
area. You can connect up to 10 devices to the CSA‐FSU as
shown in the diagram opposite.
When any device generates an alarm condition, this will be
relayed to the Master Unit which will also generate an alarm
condition simultaneously. You can use any of the devices as a
Master Unit, the diagram opposite is by way of example only.
Use 7 x 0.2mm stranded alarm cable for all the connections.
Once the wiring is complete and checked, switch on the
power supply at the mains. Each device will provide a mes‐
sage stating how it is configured. If you have a gas (smoke)
element, the device will flash its LED for 2 minutes to normal‐
ise.
DO NOT TEST THE DEVICE UNTIL THE FLASHING STOPS.
Your system is now installed and running normally.
SpeechPOD (Part No CSA‐POD) is normally supplied
with an on‐board infra red PIR motion sensor as its
detection device.
You can however trigger the SpeechPOD by other
sources instead or in addition to the PIR motion
sensor. Examples of these may be:
Door Contact, Pressure mat, alarm output from
security, fire or Building Management Systems, or
any other device that has a Clean or Volt Free
Output.
Simply connect the Normally Open (NO) contact across the TRIG IN and GND input. Each time the switch closes, Speech‐
POD will play its programmed message. Remember, SpeechPOD can be battery operated or powered from a 6Vdc power
supply connected to the +6V IN and GND inputs.
For further information or assistance with our products, please contact our Technical Department by phone or email as
detailed below.
PRODUCT INSTALLATION GUIDE
FOR THE FOLLOWING PRODUCTS
Part No: CSA‐POD
Advanced SpeechPOD
Voice Warning System
Part No: CSA‐FGS
Cig‐Arrête® Combined Flame,
Smoke and SpeechPOD
Part No: CSA‐FSV
Cig‐Arrête® Combined
Flame and SpeechPOD
Part No: CSA‐FSU
Cig‐Arrête® Combined
Flasher & Sounder Unit
Part No: CSA‐FGV
Cig‐Arrête® Combined
Flame & Smoke Detector
Part No: CSA‐FOV
Cig‐Arrête® Flame Detector
With Voice Sounder
Part No: CSA‐GOV
Cig‐Arrête® Smoke Detector
With Voice Sounder
Part No: CSA‐GSV
Cig‐Arrête® Combined
Smoke & SpeechPOD
Part No: CSA‐DUAL
Advanced SpeechPOD Dual
Voice Warning System