Ag Leader PF3000Pro Harvest & Application Operators Manual - Manual (Page 250)

Troubleshooting PF3000 Pro
Harvest Mode Ag Leader Technology
July 2003 6-10
Problem Cause Solution
Incorrect Acre
Counting. Incorrect swath See “Swath Setup” in the Setup Section and Swath
Setting in the Operation Section for instructions.
Distance is not
counting correctly
(mph is incorrect). See “Incorrect Distance and MPH” in this section.
Area calibration
number is set
incorrectly Press MENU, CAL and AREA to display the
AREA CAL number. This number should be set to
100 unless you have manually changed it to adjust
the total acres. If it is set to a different number, it
will count the percentage of acres the number
represents. Use the up/down arrow keys to adjust
the ACTUAL ACRES to the correct setting. Then
press PERFORM CAL key to correct the AREA
CAL number.
NOTE: Changing Actual Acres will change the
Area Cal number to a value other than 100, but
will correct the total acres for that field.
Distance and area
counting are not
activated. Ensure the area count switch is in up position and
the stop height number is set high enough so that
when you lower the head, AREA ON appears in
the lower right corner of the display. See “Area
Count Always Off” in this section.