GReddy e-Manage Ultimate Installation Manual - Manual (Page 9)

8
3. Initial Setup
Jumper Setting
JP11 OPTION 1
This jumper will configure the OPTION 1 port on the Front Panel of the unit.
Set to “OPEN” for Normal type(when used for pressure or A/F sensor), and “1-2” when using
GReddy Temp Sensor.
JP12 OPTION 2
This jumper will configure the OPTION 2 port on the Front Panel of the unit.
Set to “OPEN” for Normal type(when used for pressure or A/F sensor), and “1-2” when using
GReddy Temp Sensor.
JP13 Knock Signal Input 1 / Water Temp Sensor
This jumper will configure pin 32 channel in the Connector C (14 pin connector).
Set to “OPEN” for Normal type (when used for knock sensor), and “1-2” for pull-up Type
(for temp sensor).
JP14 Knock Signal Input 2 / Intake Temp Sensor
This jumper will configure pin 38 channel in the Connector C (14 pin connector).
Set to “OPEN” for Normal type (when used for knock sensor), and “1-2” for pull-up Type
(for temp sensor).
JP15 RPM Signal Input
This jumper will configure the unit to recognize the vehicle’s rpm signal.
Set to “1-2” for Normal type (Tach signal from ECU), or “2-3” for Coil(-) type.
JP16 Frequency Input / VTEC Input
This jumper will configure pin 13 channel in the Connector B (18 pin connector).
Set to “OPEN” for Karman airflow meter input signal. Set to “1-2” for VTEC input signal, and “2-3”
for VTEC input signal for K20A engine.
JP17 Frequency Output / VTM Output
This jumper will configure pin 21 channel in the Connector B (18 pin connector).
Set to “OPEN” for Karman airflow meter output signal. Set to “1-2” for Honda with VTM signal.
JP18 Injector Input / Output Signal CH1~6
This jumper will Configure the Injector Input/Output Signal Ch1~6.
Set to “OPEN” when using Injector Adj. Map to trim and add fuel, and set to “1-2” to add only.
JP19 Injector Signal CH-A
This jumper will configure the Sub Injector Signal CH-A.
Set to “OPEN” when using CH-A for the 7th injector signal for V8 and set to “1-2” for Sub Injector
or for NVCS relay.
JP20 Injector SIgnal CH-B
This jumper will configure the Sub Injector Signal CH-B.
Set to “OPEN” when using CH-B for the 8th injector signal for V8 and set to “1-2” for Sub Injector
or for NVCS relay.