Outback Power Systems GVFX Series Inverter/Charger Installation Manual - Manual (Page 48)

46
Welcome to the OutBack Power GTFX and GVFX LA Series Grid-Interactive
Inverter/Charger System
The GTFX and GVFX series Inverter/Chargers (also referred to as the FX series) offer a complete power conversion
system—DC to AC, battery charging, and an AC transfer switch—which provide complete grid-interactive service.
They can also be used in a stand-alone or back-up application. These systems are designed for indoor or enclosed
locations.
OutBack Power Systems does everything possible to assure the components you purchase will function properly
and safely when installed as instructed according to local and national electrical codes. Please read all of the
following instructions and the instructions that come with any other OutBack components that make up your
power system. Further instructions on individual FX set-ups as well as systems assemblies are included with the
FLEXware manuals.
The GTFX and GVFX LA series produces an output voltage of 127 VAC per inverter. These inverters have been
programmed to accept this voltage as the optimal amount from an AC source. This manual often refers to the
voltage as “120 VAC”. However, this is a nominal reference to the true level of 127 VAC.
Note: This product does not carry a UL1741 or ETL listing. It is not to be used in the United States,
Canada or Puerto Rico.
The GVFX and GTFX LA Series Inverter/Charger Installation Manual covers the following information:
• Safety
• FX parts, standard and optional
• Initial inspection of the component
• Preparing the mounting surface
• Fastening the FX to the mounting surface
• General electrical information
Grid-Interactive FX Series Inverter/Charger Models
Sealed Units (designed for harsher environments, but still require enclosed protection)
• GTFX2524LA (24 VDC/2500 VA)
• GTFX3048LA (48 VDC/3000 VA)
Vented Units (designed for protected environments)
• GVFX3524LA (24VDC/3500 VA)
• GVFX3648LA (48 VDC/3600 VA)
Each model FX has a single phase output marked with this symbol:
Each inverter puts out a sine wave waveform marked with this symbol:
Parts Included
• One GTFX or GVFX LA Series Inverter/Charger
• One “WARNING ELECTRICAL SHOCK” sticker to place on the exterior of the FX
• One packet of silicone grease to protect CAT 5 cable connections
• One installation manual
• One programming manual
• One Turbo Kit (sealed units)
• One DC Wiring Cover or DCC (vented units)