Agilent Technologies B2201A - Manual (Page 95)

Agilent B2200 User’s Guide, Edition 2 3-35
Front Panel Operation
Setup Menus
SELF_TEST Displays the sub menu that provides the following functions.
• EXECUTE
Starts the controller test. Wait until PASS or FAIL is displayed. Then press the
Exit key to return to the previous menu.
• RESULT
Displays the test result. Press the Exit key to return to the previous menu.
RELAY_TEST Displays the sub menu that provides the following functions.
Before starting the relay test, disconnect cables from the input connectors. And open
the outputs (end of cable is OK). For the Kelvin cable, disconnect it from the output
connectors.
• EXECUTE
Displays the following message.
Slot1
Press the up or down arrow key to select the module to be tested. Then press the
Enter key to start the relay test, or press the Exit key to cancel this operation.
Number of modules is 2 or more, the relay test will be automatically completed.
However, if the only one module is installed, the following message will appear.
Connect IV1 and 2. Press [Enter].
Then connect a cable between the input 1 and 2, and press Enter key.
After that, change the cable connection as shown in the displayed message and
repeat this for the other input connections (input 3 and 4, 5 and 6, 7 and 8, 9 and
10, 11 and 12, 13 and 14). Do not forget to open the connectors other than the
specified pair.
• RESULT
Displays the following message (example). Press the up or down arrow key to
display the test result for each module. Press the
Exit key to return to the
previous menu.
Slot1: Not performed yet