Kramer Electronics RC-IR2 - Manual (Page 18)

The Router Mode Keys
15
To switch an input to an output, point the remote control transmitter at the
remote receiver and do the following:
1. Press the VIDEO key.
2. Press the group number
1 and then press any key from <1> to <4> to switch an
input to the output.
For example, to switch input 3 in the s-Video group to the output:
Press the VIDEO key
Press 2
Press 3
To switch the master audio switcher, point the remote control transmitter at
the remote receiver and do the following:
1. Press the AUDIO key.
2. Press <1> and then press any key from <1> to <4> to switch an input to the
Master Audio Output.
7.4.1.2 Adjusting the Volume of the VP-23N
You can increase and/or decrease the volume 2 of the VP-23N using the
RC-IR2 remote control transmitter.
Increasing the Volume of the VP-23N
The volume level on the VP-23N Presentation Switcher can be adjusted
separately for the audio output of each individual switcher, as well as for the
microphone input and the Master audio output.
To increase the volume, point the remote control transmitter at the remote
receiver and do the following:
1. Press the VOL+ key.
2. Press the numeral key defining the audio signal
3 continuously until the volume
increase is satisfactory.
1 From 1 to 3 according to Table 5
2 The volume adjustment procedure is slightly different for presentation switchers, for example, the VP-23N or the VP23RC
3 See Table 6. For example, to adjust the microphone audio level, press the <4> key