Kramer Electronics RC-IR2 - Manual (Page 19)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
The Router Mode Keys
16
Table 6: Audio Output Type Key for the VP-23N/VP-23RC
Press key: To adjust the audio level of the:
1 CV group
2 s-Video group
3 VGA group
4 Microphone
5 Master audio out
Decreasing the Volume of the VP-23N
To increase the volume, point the remote control transmitter at the remote
receiver and do the following:
1. Press the VOL- key.
2. Press the numeral key defining the audio signal
3 continuously until the volume
decrease is satisfactory.
7.4.2 Controlling the VP-26 via the RC-IR2
You can control the VP-26 Presentation Switcher using the RC-IR2 to do the
following:
Switch inputs to outputs (see section 7.4.2.1)
Adjust the volume (see section 7.4.2.2)
7.4.2.1 Switching an Input to an Output
The VP-26 Presentation Switcher includes four independent switchers and
one Master audio switcher. Each independent switcher has two outputs and
the remote controller defines the groups as illustrated in Table 7.
Figure 5: VP-26 Switcher Selector Buttons
The independent switchers are defined in groups, as described in Table 7. The
Master audio is defined as Group 1.