Kramer Electronics WP-501 - Manual (Page 58)

K-Config – Defining the Control Room via the Project Navigator 53
To define the devices via the Project Navigator:
1. In the Project Navigator window area, click + to add a device to the tree.
The Add Master Device window appears. Scroll down and select RC-74DL:
Figure 87: Adding a Master Device to the Project Navigator Window
2. Click OK.
The main window appears and reflects the selection of RC-74DL:
Figure 88: Main Window after Selecting the Master Device
In main window, the:

Project Navigator shows RC-74DL as the Master Room Controller

Triggers shows the relevant events for this device

Device View shows the device front panel and lets you click any of the buttons or knob to set its behavior

Action Editor shows the relevant commands, ports and drivers available for RC-74DL