MSI X2-109 v1 - Manual (Page 59)

BIOS Commands 4-7
Version 2.0 Copyright © 2006 by LSI Logic Corporation. All rights reserved.
4.4.5 Display Adapter Time
Use the command in Table 4.5 to display the current time and date of the
selected adapter.
4.4.6 Set Factory Defaults
Use the command in Table 4.7 to set the factory defaults on the selected
adapter(s).
4.5 BIOS Commands
You can use the commands in this section to select the settings for
BIOS-related options.
4.5.1 Set or Display Bootable Logical Drive ID
Use the command in Table 4.8 to set or display the ID of the bootable
logical drive.
Note: This option does not write a boot sector to the logical drive.
The operating system will not load if the boot sector is
incorrect.
Table 4.6 Display Adapter Time
Syntax CmdTool –AdpGetTime -aN
Description Displays the selected adapter’s time in yyyymmdd HH:mm:ss format.
Table 4.7 Set Factory Defaults
Syntax CmdTool -AdpFacDefSet -aN|-a0,1,2|-aALL
Description Sets the factory defaults on the selected adapter(s). You cannot set the factory
defaults if the adapter already has a configuration defined on it.
Table 4.8 Bootable Logical Drive ID
Syntax CmdTool –AdpBootDrive {-Set –LDID} | -Get -aN|-a0,1,2|-aALL
Description • -Set: Sets the logical drive as bootable so that during the next reboot, the BIOS
will look for a boot sector in the specified logical drive.
• -Get: Displays the bootable logical drive ID.