Lenovo ThinkServer RS140 User Manual
Page 38
1. Do the following to connect the hard disk drives:
a.
1 2
: Connect the SATA combo connectors 0 and 1 of the combo SAS cable to the hard disk
drives 0 and 1 respectively.
b.
3
: Connect the power connector 1 of the combo SAS cable to the 4-pin power connector which is
near the memory modules on the system board.
c.
4 5
: Connect the SATA combo connectors 2 and 3 of the combo SAS cable to the hard disk
drives 2 and 3 respectively.
d.
6
: Connect the power connector 2 of the combo SAS cable to the other available 4-pin power
connector on the system board.
For more information, see “System board components” on page 32.
Figure 16. Connecting the 2.5-inch hard disk drives
2. Connect the SATA connectors 0 to 3 of the combo SAS cable to the corresponding SATA connectors 0
to 3 respectively on the system board. See “System board components” on page 32.
SATA1 SATA0 SATA3
SATA2 SATA4
Figure 17. Connecting the 2.5-inch hard disk drive SATA cables
26
ThinkServer RS140 User Guide and Hardware Maintenance Manual