Installing or removing the slim optical drive – Lenovo ThinkServer RS140 User Manual
Page 83
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface.
3. Remove the server cover. See “Removing the server cover” on page 55.
4. Remove the ThinkServer RAID 700 Adapter from the riser card assembly. See “Installing or removing
5. Carefully remove the three screws that secure the TR 700 Battery and then remove the TR 700 Battery
from the ThinkServer RAID 700 Adapter.
Note: Center the screwdriver when you remove the screws to avoid possible damage to any parts.
Figure 40. Removing the TR 700 Battery
6. If you want to install a new TR 700 Battery, see “Installing the TR 700 Battery” on page 69.
7. Reinstall the ThinkServer RAID 700 Adapter onto the riser card assembly. See “Installing or removing
8. Reinstall the riser card assembly. See “Replacing the riser card assembly” on page 75.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to “Completing the parts replacement” on page 106.
Installing or removing the slim optical drive
This topic provides instructions on how to install or remove the slim optical drive.
Installing the slim optical drive
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 53.
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or transmitters) are
installed, note the following:
• Do not remove the covers. Removing the covers of the laser product could result in exposure to
hazardous laser radiation. There are no serviceable parts inside the device.
.
Installing, removing, or replacing hardware
71