Lenovo ThinkServer RS140 User Manual
Page 42
1. Do the following to connect the hard disk drives:
a.
1
: Connect the SATA combo connector of the combo SAS cable to the hard disk drive 0.
b.
2
: Connect the SATA connector of the combo SAS cable to the SATA 0 connector on the system
board.
c.
3
: Connect the power connector of the combo SAS cable to the 4-pin power connector which is
near the memory modules on the system board.
d.
4
: Connect the SATA combo connector of the other combo SAS cable to the hard disk drive 1.
e.
5
: Connect the SATA connector of this combo SAS cable to the SATA 1 connector on the system
board.
f.
6
: Connect the power connector of this combo SAS cable to the other available 4-pin power
connector on the system board.
For more information, see “System board components” on page 32.
Figure 22. Connecting the 3.5-inch hard disk drives to the system board
2. If you have a slim optical drive, install the slim-optical-drive bracket, and then install the slim optical
drive. See “Removing and reinstalling the slim-optical-drive bracket” on page 82 and “Installing the
slim optical drive” on page 71.
30
ThinkServer RS140 User Guide and Hardware Maintenance Manual