Brother FAX-727 - Manual (Page 71)

62 Chapter 11
Remote Commands
Follow the commands below to access features remotely. When you call the fax machine and enter
your Remote Access Code (3 digits followed by
), the system will signal you with two short beeps
to enter a remote control command.
Remote control commands Detail Operation
95 Change Fax Forwarding
Setting
1 OFF If you hear one long beep, the change is accepted. If you hear
three short beeps, you cannot change it because the
conditions (ex. registering fax forwarding) have not been
completed. You can register your fax forwarding number by
using 4.FAX FWD NO. Once you have registered the
number, the machine will automatically turn to “FAX
FWD:ON” mode. Then, receive a Memory Status List by
entering 961. Check the List to make sure the Fax
Forwarding number you registered is correct. Now the
machine will start Fax Forwarding.
2 Fax forwarding
4 FAX FWD No.
6 FAX STORAGE ON You can set FAX STORAGE ON or OFF. (Switching Fax
Storage OFF is only possible if there are no faxes stored in
the memory, or if all faxes have been erased using Remote
Control
9 6 3 .)
7 FAX STORAGE OFF
96 Retrieve FAX
1 Memory Status List You must use a remote fax machine in order to receive a List
of stored fax message(s).
2 Retrieve all FAX
3 Erase FAX in the
memory
If you hear one long beep, you can erase fax message(s) from
the memory.
97 Check the receiving status You can check whether your fax machine has received any
fax message(s). If yes, you will hear one long beep. If no, you
will hear three short beeps.
1 DOC
98 Change Answer Mode If you hear one long beep, you can change the answer mode.
If you hear three short beeps, you cannot change it.
(Example: There is no TAD MSG when you want to change
to TAD mode.)
1 TAD
2 F/T
3 FAX
90 Exit After a long beep, you can exit remote control.