Rubicon Express RE7200 SERIES User Manual

Page 7

Advertising
background image

Photo 14

Photo 15

E. If using the RE1611 dropped track bar bracket, install the drop pitman arm. Use a good pitman arm puller to remove old one

F. Install rear sway bar links just like the factory ones.

G. Install front sway bar quick disconnects per instructions supplied with disconnects – refer to Photo 16. The latest adapter bracket

should mount down over the top of the sway bar and bolt should go up through sway bar, then through adapter bracket. The
carriage bolt head should be toward the frame at top end of disconnects. Use the thick round spacer between the bottom
disconnect and mount and put the nut on the tire side of the mount. Install disconnect tubes and snap pins.

Photo 16

Photo 17

Step 6 – Shocks and brake lines

A. Install longer front shocks. Some require bar pins to be installed through the bottom shock eyes (use light grease).

B. Position and weld on rear shock mounts – refer to Photo 17 for typical installation. The slot in the bracket is provided to place

over control arm bracket, but different shocks or lengths may require different positions. Generally, the mounts end up in the
neighborhood of 45 degrees, but it’s better to check that there is about 1” of shock travel remaining when the bump stops are
touching their pads. Install longer rear shocks.


C. Fully remove front factory brake hoses and replace with the supplied stainless steel ones. Some require positioning the block and

line vertically at the caliper. Watch line routing so they do not catch on anything during axle articulation. Use angle brackets and
e-clips at the body end.

D. Fully remove rear brake line and install new one. Watch the routing so it does not catch on anything during axle articulation.

Step 7 - Final details and adjustments

A. Install wheels and lower vehicle.

B. Adjust the track bars to fit into the mounts with the axles as centered as possible (centering is not hyper critical).

C. Thoroughly bleed brake lines per factory manual and check for leaks and a firm pedal.

D. Torque all bolts to factory specs and double-check your work.

RE7200G Page 7 of 8

Advertising