Lull 1044C-54 Series II Operation Manual - Manual (Page 23)

INSTRUMENTS AND CONTROLS
15
SHIFT SELECTOR
Shift Selector
The shift selector is located on the steering wheel
column. It controls vehicle travel direction and
transmission speed range.
Direction Control
Vehicle travel direction is controlled by moving the shift
lever to one of three positions:
FORWARD (F): Move the lever fully forward to select
forward vehicle movement.
NEUTRAL (N): Move the lever to the center position to
disengage the transmission. The engine may be started
only when the transmission is in NEUTRAL.
REVERSE (R): Move the lever fully rearward to select
reverse vehicle movement.
Speed Range Selection
The transmission has four speed ranges in forward and
three in reverse. To select different transmission speed
ranges, rotate the selector handle to the desired
position. Speed ranges may be selected while the
vehicle is moving in forward or reverse.
Note: The transmission requires 3 seconds
immediately after engine start for
self-diagnostics. Always wait at least 3 seconds
after engine start before engaging transmission.
The following table shows the maximum travel speed
forward or reverse, (See note below) for each position
on the selector:
Note: If the fourth speed range is selected while
traveling in reverse, the transmission will remain
in third.
Neutral Lock
Neutral Lock
The shift selector is equipped with a neutral lock (4).
To lock the shift lever in the NEUTRAL position:
1. Place the lever in the NEUTRAL position
2. Move the neutral lock lever to the (N) NEUTRAL
LOCK position.
To unlock, move the neutral lock lever to the (D) DRIVE
position.
SHUTDOWN OVERRIDE SWITCH
Shutdown Override Switch
The shutdown override switch (5) is an internally lighted
rocker switch located on the instrument panel, located
below the gauge cluster. Pressing the forward side of
the switch delays engine shutdown for 30 seconds. The
switch resets the shutdown timer to 30 seconds and
may be used repeatedly. However, continuously
holding the switch will not reset the 30 second timer.
ZF 4WG-98 TC Speeds
POSITION SPEED
1 4.2 mph
2 7.0 mph
3 16.5 mph
4 21.5 mph
F
N
R
1
2
3
4
H1022
N D
F
N
R
1
2
3
4
H1023
4
TRANSMISSION
DECLUTCH
OV0040
5