Lull 1044C-54 Series II Operation Manual - Manual (Page 45)

FLUID & LUBRICANT SPECIFICATIONS
37
TRANSMISSION OIL
SPECIFICATIONS
The following table shows approved lubricants and
associated temperature ranges for use with ZF 4WG
series transmission.
FUEL REQUIREMENTS
General
Diesel fuels are blended to meet the local temperature
requirements. The standard grades are:
1. 1D for temperatures -22 to +86 °F
(-30 to +30 °C).
2. 2D for temperatures +14 to +122 °F
(-10 to +50 °C)
There are two main classifications of diesel fuel in
general use:
1. Low-sulphur, “on-highway” diesel fuel.
2. Medium-sulfur, “off-highway” diesel fuel. This fuel
contains blue dye.
The engine manufacturer specifies the diesel fuel
requirements. Additional information can be found
below and in the engine manufacturer’s Operator’s
Manual.
Consult your local fuel distributor for the properties of
the diesel fuels available in your area.
John Deere Engines
Use of regular-sulfur “off-highway” diesel fuel is
recommended.
If low-sulfur “on-highway” diesel fuel is used, John
Deere Diesel Fuel Conditioner (TY22030) must be
added.
Use of low-sulfur fuel without the specified conditioner
may cause premature failure of the engine’s fuel system
components and void the warranty.
Transmission Oil Selection Chart
ZF 4WG-98TC Transmissions
Oil Grade
Min. Oil
Temperature
for Starting
Engine
Min. Oil
Temperature
for Engaging
Transmission
Recommended
Mobilfluid ® 424 -4 °F (-20 °C) +86 °F (+30 °C)
Engine Oils
SAE 20W-20 +14 °F (-10 °C) +41 °F (+5 °C)
SAE 15W-40 +5 °F (-15 °C) +32 °F (0 °C)
SAE 10W,
10W-30,
10W-40
-4 °F (-20 °C) +23 °F (-5 °C)
Automatic Transmission Fluid (ATF)
ATF -22 °F (-30 °C) +14 °F (-10 °C)
Approved Lubricants (Engine Oils)
API CD/ CE/ CF/ SF/ SG
MIL-L-2104 C/ D/ E
MIL-L-46152 C/ D/ E
SAE 10W
SAE 10W-30
SAE 10W-40
SAE 15W-40
SAE 20W-20
Automatic Transmission Fluid (ATF) may only be used
at ambient temperatures below +14 °F (-10 °C)