Smittybilt 140010 Street Light Bar - Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Street Light Bar
Models 110010, 110020, 110030, 110040, 110050,
110060, 120010 and 140010
Light Bar Instructions
Models 110010, 110020, 110030, 110040, 110050, 110060, 120010 and 140010
Hardware Kit Contains: Recommended Tools:
2) 3/8” x 1” Hex Head Bolts 9/16” Socket Wrench
2) 3/8” Washers Black Marker
Drill and ½” drill bit
Metal punch and Hammer
Step 1: Hold the Light Bar up to the face of the bumper where the round mounting brackets are flat against
the bumper.
Step 2: While the Light bar is positioned on the bumper, mark around the two mounting brackets onto the
bumper. Next, remove the light bar and set aside. You should have two circular marks on the bumper.
Step 3: Mark a ‘X’ through each circle, this will give you the center. Use a metal punch and hammer to
punch a pilot hole through the center of the circle.
Step 4: Drill a ½” hole through the pilot marks. NOTE: Make sure the holes are free of metal burs.
Step 5: Align the Light Bar mounts to the drilled holes and place a 3/8”x 1” bolt and the 3/8” washer through
the back side of the bumper and thread into the light bar bracket. After final positioning, torque each bolt
location to 15-20 ft/lbs. NOTE: Removing the bumper may be easier on some models.
Model 110020 and 110030
Step 1: Drill out the two square license plate holes with a ½” drill bit.
Step 2: Perform step 5 above. NOTE: Mount the license plate back behind the Light Bar bracket.
Products licensed to Smittybilt, a division of Transamerica Auto Parts, by Fichter Deisgns are protected by US patent law and International Copy Right law. US
Patent #6588783, # 6874801, #7416202. Other patents and continuances pending. N-fab products configuration also protected by International Trade Dress Law.
All Design and Patent infringements will be prosecuted to the full extent of the law.