Smittybilt T0678QC Nerf-Step - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 W. Artesia Blvd, Compton, CA 90220
Installation Instructions
Nerf Step (Part# T0678CC) 05-10 Toyota Tacoma Double Cab
2” Main tube 5’or 6’ Bed
Nerf Step (Part# T0678QC) 07-10 Toyota Tacoma Double Cab
Short Bed
Bolt Kit:
•
10) 8mm x 1” bolts
•
10) 5/16” washers
•
10) 8mm lock washers
Tools Needed:
•
13mm wrench
1. Remove the bars from their box and
locate the bolt kit. Remove any factory hardware.
See Figure 1
Figure 1
2. Position the step to the driver side of the vehicle. NOTE: The short end of the step board should be located at the front of the
vehicle. Test fit the step board to the factory hole locations. NOTE: The step should line up with the existing factory bolt
locations.
3. Starting with the center bracket, start one 8mm hex bolt, 8mm lock
washer and 8mm
flat washer into the factory bolt location. NOTE: Step board should hang in
location with the bent flange toward the rear of the vehicle. Start the other
8mm nut, 8mm lock washer and 8mm washer on the same bracket. NOTE:
Hand tighten.
See Figure 2
(Figure 2)
4. Start all of the remaining 8mm hex bolts, 8mm nuts, 8mm
lock washers and 8mm flat washers at each bracket. NOTE:
The front bracket only uses one 8mm bolt and washer per side.
Torque each bolt to 15ft/lbs.
See Figure 3
5. Repeat installation procedure on the other side.
(Figure 3)
This concludes the step installation.