Smittybilt 53032 Bull Bar - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220
Installation Instructions
Bull Bar (#53031&53032)
02-05 Ram Pickup 1500
NOTE: Please read this information before attempting to install this product. Smittybilt is in no way responsible for any
damage to the vehicle or personal injury that may occur during the installation or use of this product. Check components
received with components listed below. NO DRILLING REQUIRED.
QTY
DESCRIPTION
1 Front Guard
2 Lower Support Brackets
8 M10 x 35 Hex Bolt-zinc plated
8 M10 Hex Nut-zinc plated
16 M10 Flatwasher-zinc plated
8 M10 Split lock washer-zinc plated
Step One: Locate the left and right lower support brackets. Remove the tow hook bar (if equipped) and locate the two
outermost holes in the front of frame as shown in fig.#1. For vehicles not equipped with tow hooks, the front plastic
filler panel must be removed. Place the brackets into position and secure with the factory bolt and 3/8 hardware as
shown in Fig.1. (or) Fig 2. Repeat this process for the other side. Vehicles without factory tow hooks require two 3/8
nuts, bolts, washers per side. (included in kit) Do NOT fully tighten at this time.
Step Two: Loosely attach the Grille Saver to the lower support brackets with the 3/8 hardware as shown in Fig.2-3
Step Three:
After checking for proper clearance and alignment of the Grille Guard on the vehicle fully tighten all
hardware.
Fig. #1 Fig. #2