IKA ULTRA-TURRAX Tube Drive control - Manual (Page 20)

20
UTTD_c_022014
NAMUR
Commands
Function Remark
IN_NAME Request designation.
Start the Remote control
function. Device Keypad not available
except “power” button is
pressed, after this command
is sent to device. "Remote"
symbol is displayed.
RESET Switch to normal operation Device Keypad available
again, and clear the "Remote"
symbol.
IN_PV_X
X=4 Read actual speed value
IN_SP_X
X=4 Read target value input
OUT_SP_X m
X=4 Set target speed value, input:
rpm
START_X
X=4 Switch on appliance remote
function.
Start value function with setting.
IN_SOFTWARE Request software ID,
number, date and version
Commissioning
Pay attention to the ambient conditions listed in the “Technical Data”.
If these conditions are met, the unit is ready for op-
erating when the mains plug has been plugged in.
Fit the tube carefully and ensure it is
properly attached.
If above procedures are not followed,
safe operation can not be guaranteed
and/or the equipment may be damaged.
8
Switching on
C Press “Power” button (A) to switch on the device, see Fig. 1.
 The start-up screen will be displayed for several seconds. This
screen shows the unit designation and the software version.
 Then, the system check screen will be displayed for several sec-
onds.
9