IKA ULTRA-TURRAX Tube Drive control - Manual (Page 21)

21
UTTD_c_022014
Symbols are shown on the screen, including the working mode set-
ting, the target speed, the maximum rotation speed (rpm) and timer
maximum value etc. of the device.
Symbols Explanation

Maximum rotation speed of the device (If “Turbo” function is acti-
vated, the maximum rotation speed could reach 8000 rpm).
 Rotation symbol (The symbol will change into  or  if “Rev”
function is activated).
 Rotation speed setting.
 Operation mode.
 “Timer” maximum value of the device.
 “Timer” symbol.
 After the system check screen, the working screen will appear and
the device is ready for operation.
Note: Figure above shows specified values corresponding to the default
settings at delivery.
Factory setting
The device is supplied with following factory setting:
Menu Settings:
mode
A
max rpm 6000 rpm
timer max 30 minute
language English
Working Setting:
target rpm
400 rpm
timer sec off
rev sec off
10
Resetting parameters to factory setting 10.1
To reset the parameters to the factory settings, proceed as following:
• Pull out main plug from the device.
• Hold the controller buttons “Menu/Back” and “Timer” simultane-
ously and re-insert main plug in power outlet.
• The unit is now reset to the factory settings.





