JLG 2658E3 Service Manual - Manual (Page 47)

SECTION 2 - PROCEDURES
3120878 – JLG Lift – 2-35
DATALOG
ON
DRIVE
LIFT
DECK
PUMP
RENTAL
ERASE RENTAL
(YES:ENTER,NO ESC)
MAX. TEMP
MIN. TEMP
MAX BATTERY
Displays total controller on time
NOTE: Up to four minutes lost at switch-off
Displays total controller drive operation time
Displays total controller lift operation time
Displays total controller deck operation time
NOTE: Not displayed if POWER DECK = NO
Displays total controller pump running time
NOTE: Includes drive, lift up, deck and steer
Displays total controller pump running time
NOTE: Can be reset
Not available in level 3
ENTER resets rental datalog time to zero
Displays maximum measured heatsink temperature
Displays minimum measured heatsink temperature
Displays maximum measured battery voltage
VERSIONS
ASPC
ANALYZER
Displays controller software version
Displays analyzer software version
ACTIVATE TESTS
YES:ENTER,NO:ESC
RUN SYSTEM TEST
(Machine must be fully
lowered before run-
ning systems test)
Not available once tests are activated
ENTER activates system test
NOTE: Cannot be done while controller is use (trigger switch
closed)
ENTER starts system test
Not available until tests are activated
Displays messages while system test runs
Some messages are prompts, requiring user intervention
ENTER can be pressed if a fault has been noted and to con-
tinue the system test.
NOTE: A flashing message is critical, and prevents the sys-
tem test from running.
Table 2-7. Analyzer Menu Structure
TOP LEVEL MENU SUB LEVEL MENU
ITEM TO BE VIEWED
OR CHANGED
DESCRIPTION DISPLAY