Input carrier disassembly, Input carrier disassembly -38 – JLG 680S Service Manual User Manual

Page 86

Advertising
background image

SECTION 3 - CHASSIS & TURNTABLE

3-38

– JLG Lift –

3121234

Input Carrier Disassembly

1. Place the Carrier (3A) on a press with the spline end

up and drive the Planet Shaft (3E) out of the Carrier
(3A).

2. Slide the Planet Gear (3F) and the two Thrust Wash-

ers (3B) out of the Carrier (3A).

3. Remove the 14 needle Bearings (3C) from the bore

of the Planet Gear (3F).

4. Repeat steps 1 through 3 for each of the two remain-

ing planet gears.

Figure 3-30. Input Carrier Disassembly

3A. Carrier
3B. Thrust Washers
3C. Needle Bearings
3E. Planet Shaft
3F. Planet Gear

Advertising
See also other documents in the category JLG Special machinery: