2N NetStar Admin manual - Manual (Page 200)

200
7.7 AutoClip Routers
AutoClip Router
The AutoClip routers are used for automatic routing of incoming calls and SMS
messages in case a match is found in the assigned AutoClip router. Records are added
to the AutoClip routers while outgoing calls or SMS messages are passing through the
carriers to which the AutoClip routers are assigned. All you need to add a record on an
SMS is to send it. A record on an outgoing call can be added only if the call has been
rejected or unanswered by the called party. For easier comprehension and use,
examples are provided at the end of this chapter.
AutoClip Router Use
To set the AutoClip routers use the menu. The menu is Routing – AutoClip Routers
divided into two parts. A list of available AutoClip routers is displayed on the left. Add,
delete or rename the AutoClip routers using the context menu. Moreover, there is an
option, which enables you to add the default Autoclip router. Having selected a Update
router, you can see its record listing (the last 100 records) and also set some of its
parameters in the right–hand side of the menu.
You can assign the AutoClip routers virtual ports or virtual port types in the tag. Basic
Assign the AutoClip router to calls and SMS messages separately. However, one and
the same AutoClip router may be assigned in either case. Each AutoClip router record
(row) has a flag, identifying an outgoing call or an SMS message. Each record is stored
with a set of parameters. Some of the parameters depend on the call (CPN, CLI) and
some on the AutoClip parameters assigned to the calling user or to the incoming virtual
port. To set the above–mentioned AutoClip parameters use the
Global data –
menu. Remember to assign the parameters to calls and SMS Autoclip parameters
separately (using the same parameter sets again). To assign the parameters to
outgoing calls use the
option of the tag on the user or group Properties Routing
level. To assign the parameters to outgoing SMS messages use the Messages tag on
the user or group level.
If these AutoClip parameter sets are not assigned to a user (or
group), the user's records cannot be added to the AutoClip
router!
AutoClip Router Setting
You can set four parameters for a selected AutoClip router: