2N NetStar Admin manual - Manual (Page 55)

55
Expert tag
AT commands
You can add AT commands here to set the module properties. These AT commands are
executed upon every PBX restart
. Use the arrows in the or GSM/UMTS card restart
right–hand part of the section to specify the sequence of the commands. The Timeout
column sets the time during which the answer to the command entered is awaited. The
columns includes a brief statement on whether or not the command was Result
successful. For specific answers see the
section. Answers for selected
Answers for selected
Here find an answer to the AT command selected in the left part of the screen.
Net code locks
Use a special licence to restrict a module to a specific network. This restriction is
Use a special licence again to unlock the status. The lock supports up to 8 permanent.
networks.
Lock mode:
Unused – the lock is not activated.
First enable – the module is locked for the first network to which it logs in.
Enable – the module may log in to the selected networks only.
Disable – the module may log in to all networks except for those selected in the
section. Net code
SIM num locks
Use a special licence to restrict a module to a specific SIM card. This restriction is
Use a special licence again to unlock the status. The lock supports up to 4 permanent.
SIM cards.
Lock mode:
Unused – the lock is not activated.
First enable – the module is locked for the first SIM card inserted.
Enable – the selected SIM cards may log in to the module only.
Disable – all SIM cards may log in to the module except for those selected in the
section. SIM num
Audio parameters
This block of parameters helps you set audio profiles for various Siemens MC55/MC55i
GSM module versions.
MC55 Audio Profile – select the module version.
Tx gain – set the transmitted audio signal intensity increase - not
. implemented yet
Rx gain – set the received audio signal intensity increase - not implemented
. yet