Despatch RAD1-42 -2E with Protocol 3 - Manual (Page 31)

RAD1-42-2E Oven Owner’s Manual A PPENDICES
Version 1 31
Copyright © 2012 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
8.2. MRC5000 Setup (Optional)

Refer to instructions provided by the recorder manufacturer for
more specific installation notes.
Temperature is retransmitted to the MRC5000 recorder from the controller. To set up the
recorder:
1. Ensure hardware jumper JU1 is in place for the 5 VDC setting (Refer to MRC5000 Manual
included).
2. Move MODE to PROG/TEST/CAL to display Prog .
3. Press ▼ twice to display Inps
. Move to each Parameter Code using ▼or ▲. Adjust each
Parameter Code using the settings in Table 5.
4. After adjusting all settings, move MODE to RUN . Display on both the recorder and controller
should read the same.
Table 5. MRC 5000 Settings.
Parameter Code
Degrees C Degrees F
Inps 17 17
Icor 0 0
diSP On On
dPOS 0 0
EUU
4
400 752
EUL 4 0 32
ChUP 400 800
5
ChLO 0 0
DFF 1 1
8.3. Electrical Schematics
The following pages contain electrical schematics for the RAD1-42-2E oven.
4 These values must match the settings RetOutLo and RetOutHi on the Protocol 3 Control page. For
example, if RetOutLo is 32, EUL must read 32.
5 Change 0-400 chart paper to 0-800 chart paper. Depending on the equipment used, 0-600 paper may be
used if the maximum temperature is 500 degrees F.