ElmoMC ExtrIQ Digital Servo Drives-Hawk - Manual (Page 18)

Hawk Installation Guide
MAN-HAWIG (Ver. 1.401)
www.elmomc.com
18
Chapter 3: Installation
The Hawk must be installed in a suitable environment and properly connected to its voltage
supplies and the motor.
3.1. Site Requirements
You can guarantee the safe operation of the Hawk by ensuring that it is installed in an
appropriate environment.
Feature Value
Ambient operating temperature -40 °C to +70 °C (-40 °F to 160 °F)
Maximum operating altitude 12,000 m (39370 feet)
Maximum non-condensing humidity 95%
Operating area atmosphere No flammable gases or vapors permitted in area
Models for extended environmental conditions are available.
Caution:
The Hawk dissipates its heat by convection. The maximum operating ambient
temperature of 0 °C to 40 °C (32 °F to 104 °F) must not be exceeded.
3.2. Unpacking the Drive Components
Before you begin working with the Hawk, verify that you have all of its components, as follows:
• The Hawk servo drive
• The Composer software and software manual
The Hawk is shipped in a cardboard box with Styrofoam protection.
To unpack the Hawk:
1. Carefully remove the servo drive from the box and the Styrofoam.
2. Check the drive to ensure that there is no visible damage to the instrument. If any damage
has occurred, report it immediately to the carrier that delivered your drive.