JUMO 705020 mTRON T - Analog Input Module, 4-Ch. Operating Manual - Manual (Page 62)

8 Online parameters
62
8.1.4 LED test
Setup dialog
Parameter
Parameter Selection/settings Description
S LED To test the LED, click the required status
to select it (OFF, red, or green).
After selection, the LED enters the cho-
sen status immediately. This function is used to test the electrical
function of the "S" LED (Status).
1 LED To test the LED, click the required status
(OFF or yellow) to select it.
After selection, the LED enters the cho-
sen status immediately. This function is used to test the electrical
function of LED "1".
TIP!
An LED maintains the set status until a new status is set or until the "LED test" dialog window
is closed.