Landoll SL/SLB/SLP/SLPB/SLPB TURFMAKER III - Manual (Page 47)

OPERATION
3-9
Transmission Clutch
The clutch is disengaged when power (12 volts) is
applied. If there is a power failure or electrical problem,
the seeder will continue to operate, so the machine must
be raised to stop seeding.
1. Seed shafts will not rotate when the machine is
backed up.
2. The switch box contains a standard 5 amp fuse.
3. The clutch must be disengaged (power applied)
when seed shafts are turned manually for calibration.
Charging the Hydraulic System
Ensure that the hydraulic system is full of oil. If a
hydraulic component is removed, repaired, or replaced
the system, must be purged of air before operations. To
purge the system or air, unpin the rod end of both
cylinders. Align or prop the cylinders into position so that
the rod will not interfere with anything during its travel.
Slowly engage the tractor hydraulics fully extending and
retracting both cylinders. Repeat several times until the
action of both cylinders is positive and immediately
responsive. Do not loosen or crack any fittings.
Reconnect the rod end of both cylinders.