Lenze E84AYCPM User Manual
Profibus, Ä.k6~ä
Advertising
Table of contents
Document Outline
- E84AYCPM (PROFIBUS®)
- Contents
- 1 About this documentation
- 2 Safety instructions
- 3 Product description
- 4 Technical data
- 5 Installation
- 6 Commissioning
- 7 Data transfer
- 8 Process data transfer
- 9 Parameter data transfer
- 9.1 Addressing of the parameter data
- 9.2 DRIVECOM parameter data channel (DP-V0)
- 9.3 PROFIdrive parameter data channel (DP-V1)
- 9.4 Consistent parameter data
- 10 Monitoring
- 11 Diagnostics
- 12 Error messages
- 12.1 Short overview of the PROFIBUS error messages
- 12.2 Possible causes and remedies
- Connection to 8400 standard device lost [0x01bc3100]
- Memory: No access [0x01bc5531]
- Memory: Read error [0x01bc5532]
- Memory: Write error [0x01bc5533]
- Restart after watchdog reset [0x01bc6010]
- Internal error [0x01bc6011]
- Internal error [0x01bc6100]
- Internal error [0x01bc6101]
- Internal error [0x01bc6110]
- Invalid parameter set [0x01bc641f]
- Error: Lenze settings loaded [0x01bc6420]
- Profibus watchdog: Monitoring time elapsed [0x01bc8130]
- Profibus: Data_Exchange state exited [0x01bc8131]
- Profibus watchdog: DP-V1 MSC2 monitoring time exceeded [0x01bc8132]
- 13 Parameter reference
- 13.1 Parameters of the communication module
- C13850 | All words to master
- C13851 | All words from master
- C13852 | All words to standard device
- C13853 | All words from standard device
- C13860 | Settings
- C13861 | Bus status
- C13862 | Bus counter
- C13863 | Baud rate
- C13864 | Active station address
- C13865 | Display: Most recent PRM data
- C13866 | Display: Most recent CFG data
- C13867 | Display: Most recent diagnostic data
- C13880 | Reaction on communication fault
- C13881 | Monitoring time: Data exchange
- C13882 | Monitoring time: Watchdog
- C13885 | Clear process data
- C13886 | Set ext. diagnostic bit by
- C13887 | Suppress signalling diag. mess. upon
- C13899 | Station address
- C13900 | Firmware product type
- C13901 | Firmware compilation date
- C13902 | Firmware version
- C13920 | Display: DIP switch setting
- 13.2 Table of attributes
- 13.3 Implemented PROFIdrive objects (DP-V1)
- 13.1 Parameters of the communication module
- 14 DIP switch positions for setting the station address
- Index
- Your opinion is important to us
- Contents