MTS Series 793 - Manual (Page 145)

Item/Description Callout
Command Amplitude 1
Target Setpoint 2
Taper Time 3
Tapered waveform starting or resuming from the mean level. 4
Tapered waveform stopping or holding from the command amplitude
to the mean level. 5
Ramp Time Settings
Ramp Times set the time for MPT processes to ramp to commanded levels.
Access
Tools menu > Channel Options > Channel Options window > Command Options tab
Description Item
Sets the ramp time from stop to run states. Applies in
procedures where the MPT application’s Option Editor Start
window Command Stop Behavior selection is either Ramp
to Zero or Ramp to Mean.
Sets the ramp time from run to stop states. Applies in
procedures where the MPT application’s Option Editor Stop
window Command Stop Behavior selection is either Ramp
to Mean or Ramp to Zero.
MTS Series 793 Control Software 145
Station Manager Application