MTS Series 793 - Manual (Page 231)

Settings Channel Type
Note:
Fullscale Min/Max units and values may vary, depending on
the device being driven.
Channel Groups
About Channel Groups
You can create Master Command and Master Span channel groups that allow the Station Manager application
to control individual actuators in a multichannel station as a unit.
A channel group allows these four actuators to be controlled as a single unit.
Master Command groups
A Master Command channel group receives a common command signal. Use the Channel Options window
Master Command tab to define Master Command groups.
Commands are applied to a Master Command group through:
• The Station Manager Function Generator panel.
• The Manual Command window.
• The Setpoint and Span window.
MTS Series 793 Control Software 231
Station Setup