MacDon HC10 for D-Series - Manual (Page 42)

UNLOADING AND ASSEMBLY
6. Remove the hose guide (A) located near the left-hand
center leg. (For 20 ft. and larger headers, remove this
support from its mounting position on sheet metal hose
cover.)
Figure 3.11: 15 ft Header Shown
7. Attach hose assembly (A) onto the left-hand center leg
and install nut on lower bolt (C). Ensure correct hole is
used when attaching hose assembly (use hole (D) for
15-foot headers).
NOTE: For headers with a sheet metal hose
cover, install bolts from the outboard side.
8. Install other bolt (B) through bracket, spacer, and hose
assembly and secure with a nut.
9. Tighten both bolts.
Figure 3.12: 20–35 ft Header Shown
A - Hose Assembly B - Bolt
C - Mounting Position for 20–35-Foot Headers
D - Mounting Position for 15-Foot Headers
169254
34
Rev. D