MacDon HC10 for D-Series - Manual (Page 98)

MAINTENANCE
5.4 Lubrication
5.4.1 Lubricants
Your machine can operate at top efficiency only if clean lubricants are used.
Use clean containers to handle all lubricants.
Store in an area protected from dust, moisture, and other contaminants.
Lubricant Spec. Description Use
Grease SAE Multi-Purpose High temperature, extreme
pressure (EP).
0-1% Max Molybdenum
Disulphide (NLGI Grade 2).
Lithium Complex Base.
Base Oil Viscosity of 190-250
CST @ 40C. As required unless otherwise
specified.
5.4.2 Greasing Procedure
CAUTION
To avoid personal injury, before servicing header
or opening drive covers, follow procedures in
5.1
Preparation for Servicing, page 87 .
1. To avoid injecting dirt and grit, wipe grease fitting with
a clean cloth before greasing.
2. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
3. Leave excess grease on fitting to keep out dirt.
4. Replace any loose or broken fittings immediately.
5. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway. Replace
fitting if necessary.
169254
90
Rev. D