Sensaphone 800 - Manual (Page 45)

Chapter 4: Communications Programming
43
3. Press the corresponding Zone number key.
4
MAX CALLS
5
TEMP LIMITS
6
CALIBRATE
8
CLOCK
3
INTERCALL
TIME
7
RECOGNITION
TIME
9
LISTEN TIME
SOUND
0
ID NUMBER
POWER
1
CALL
DELAY
2
VOICE
REPS
The 800 will play back your recorded message.
To erase a Zone or ID message:
1. Press the SENSOR ON/OFF key.
SENSOR
ON/OFF
2. Press the MESSAGE key.
MESSAGE
The 800 will say “Enter message number.”
3. Press the Zone Number or ID key.
0
ID NUMBER
POWER
The 800 will say, “Message erased.”
4 .2 The Unit ID Number
The Unit ID Number is the identification number of the Model
800. This number is typically the telephone number where the
unit is installed, or it may be designated using any number that
best suits your application.
The purpose of the Unit ID Number is to immediately provide the
source of any alarm, especially when using multiple Model 800
units in a complex monitoring system. When the Model 800 is
called from a remote location, it always begins its message with
the identification number:
“Hello, this is (Unit ID Number).”