Rockwell Automation 20G PowerFlex 755 Drive Embedded EtherNet/IP Adapter - Manual (Page 13)

Rockwell Automation Publication 750COM-UM001E-EN-P - October 2013 13
Getting Started Chapter 1
• Automatic Device Configuration (ADC), which is an ‘RSLogix 5000
software, version 20.00, feature’ that supports the automatic download of
configuration data. This occurs after the Logix controller establishes an
EtherNet/IP network connection to a PowerFlex 755 drive (firmware
revision 4.001 or later) and its associated peripherals.
• Web pages, viewed by using a web browser, that show information about
the embedded EtherNet/IP adapter, its host drive, and DPI devices
connected to the drive.
• Configured e-mail messaging to desired addresses when selected drive
faults occur and/or are cleared, and/or when the embedded EtherNet/IP
adapter takes a communication or idle fault action.
• Access to any PowerFlex drive and its connected peripherals on the
network to which the embedded EtherNet/IP adapter is connected.
Compatible Products At the time of publication, the embedded EtherNet/IP adapter is compatible
with Allen-Bradley PowerFlex 755 drives.
Required Equipment Some of the equipment that is required for use with the embedded EtherNet/IP
adapter is shipped with the drive, but some you must supply yourself.
Equipment Shipped with the Drive
Since the EtherNet/IP adapter is embedded on the Main Control Board in the
PowerFlex 755 drive, it is always an integral part of the drive and, therefore, does
not require installation instructions.
User-Supplied Equipment
To configure the embedded EtherNet/IP adapter, you must supply the following:
❑ A small screwdriver
❑ Ethernet cable (for details, see the EtherNet/IP Media Planning and
Installation Manual, ODVA publication 148 available on the ODVA
website at
http://odva.org/Home/ODVATECHNOLOGIES/
EtherNetIP/EtherNetIPLibrary/tabid/76/Default.aspx )
❑ Ethernet switch (for details, see the Ethernet Design Considerations
Reference Manual
, publication
ENET-RM002 )