Brother FAX 770 - Manual (Page 98)

88
C H A P T E R T E N
Remote Retrieval
This section is for the FAX 870MC and MFC 970MC. (If you have the FAX 770,
please see Chapter 9 for your remote fax options.) You can call your FAX/MFC
from any touch tone phone (or remote Group 3 fax machine) and use a Remote
Access Code and other button presses to retrieve voice (and fax) messages. You can
also program and change some settings for your Message Center.
Using Remote Access Code
1 Dial your FAX/MFC phone number from a touch tone phone.
2 When your FAX/MFC answers and beeps, immediately enter your Remote
Access Code.
3 The FAX/MFC signals the kinds of messages received:
1 long beep—Fax message(s)
2 long beeps—Voice message(s)
3 long beeps—Fax and Voice message(s)
No beeps—no messages
4 The FAX/MFC then prompts you with two short beeps to enter a command.
If you wait longer than 30 seconds to enter a command, the MFC hangs up.
If you enter an invalid command, the FAX/MFC beeps three times.
5 Press 9 0 to reset the FAX/MFC when you finish.
6 Hang up.
If your FAX/MFC is set to MANUAL mode, you can access the Message Center by
waiting about 2 minutes, then entering the Remote Access Code within 30 seconds.
Changing Remote Access Code
Enter your Remote Access Code when the FAX/MFC picks up your call, so
you can access features remotely. The access code is preset to 159 , but
you can change this.
1 Press Function , 8 , 7 .
2 Enter a three-digit number from 000 to 999. The “ ” cannot be changed.
Do not use the same digits that appear in your Fax Receive Code,
Telephone Answer Code, or Personal Mailbox Codes.
3 Press Set .
4 Press Stop to exit.
See Operation
from Extension
Telephone
p. 39