Rockwell Automation 900-TC32 Digital Temperature Controllers, Series B - Manual (Page 306)

Publication 900-UM007D-EN-E - January 2011
5-78 Parameter Functions & Definitions
Figure 5.12
Additional PV Display
Function: This parameter allows you to configure the controller so that only
the PV is displayed. It is added to the top of the Operation function group. It
gives you the option of displaying the PV and SP (normal) or just the PV.
Manipulated Variable (MV) Display
Function: This parameter allows you to configure whether or not the
manipulated variable is displayed.
The manipulated variable is displayed when the Manipulated Variable monitor
(heating) and Manipulated Variable (cooling) parameters are set to ON, and
not displayed when these parameters are set to OFF.
Table 5.CO
Configurable Range Units Default Value
0.0…999.9 Seconds 0.0
Table 5.CP
Selections Default Selection
on: Displayed
off: Not displayed
off
PV before passing through filter
A
PV after passing through filter
0.63 A
Time
Constant
Time
Input Digital Filter
puad
o-dp