Rockwell Automation 1769-IF8 Compact 1769-IF8 Analog Input Module - Manual (Page 11)

Compact I/O 1769-IF8 Analog Input Module 11
Publication 1769-IN067B-EN-P - September 2005
Labeling the Terminals
A removable, write-on label is provided with the module. Remove the label from
the door, mark the identification of each terminal with permanent ink, and slide the
label back into the door. Your markings (ID tag) will be visible when the module
door is closed.
Removing the Finger-Safe Terminal Block
When wiring field devices to the module, it is not necessary to remove the terminal
block. If you remove the terminal block, use the write-on label on the side of the
terminal block to identify the module slot location and type. RTB position can be
indicated by circling either the ‘R’ for right side or ‘L’ for left side.
To remove the terminal block, loosen the upper and lower retaining screws. The
terminal block will back away from the module as you remove the screws. When
replacing the terminal block, torque the retaining screws to 0.46 Nm (4.1 in-lbs).
wiring the
finger-safe
terminal block
upper retaining screw
lower retaining screw