Moving with rod or pipe rollers – Rockwell Automation 6000 PowerFlex Medium Voltage Variable Frequency Drive Installation Instructions User Manual
Page 17
Rockwell Automation Publication 6000-IN006A-EN-P - April 2014
17
Shipping and Handling Procedures
Chapter 1
Figure 4 - Channel Steel Base Location
Bolt or weld the drive cabinet on the profile steel base (Refer to
). A reliable connection must be made between the steel base
and the cabinet. The steel base profile shall be reliably grounded.
Moving with Rod or Pipe Rollers
This method is only suitable when there are no inclines and the drive is moved on
the same floor.
Boards with cross section of about 50 ×150 mm (2 × 6 in.) and length of at least
300 mm (12 in.) longer than the drive must be placed under the wooden skid.
Lift the cabinet and carefully and slowly lower the drive cabinet onto the roller
pipes until the drive weight is borne on the roller pipes. Do not remove the
shipping skid; the skid is required for this process (see
Roll the drive to its destination location. Steady the cabinet to prevent tipping.
Channel Steel Base