Rockwell Automation 441-PEN25 Enpac Ex Data Collector - Manual (Page 86)

Publication GMSI00-UM001A-EN-E - February 2005
80 Collecting and Reviewing Data
Selecting a Route
The Enpac Ex Data Collection program operates on a route. This can be the
Default Route or a route you create and unload with your computer software.
Routes that you create with your computer software may contain multiple
points, and each point may cause the Enpac Ex to perform multiple
measurements. Note that the default route contains only one measurement
point.
1. Select Data Collection from the Main Menu and press the READ/OK
key. The Data Collection screen appears.
2. Highlight Route and press the RIGHT ARROW key. The Select Route
screen appears.
3. Use the UP or DOWN ARROW keys or tap the name of the route to
select the route. Then press the LEFT ARROW key. The route begins
with the first measurement definition in the route.
4. To leave the Select Route screen without selecting a route, tap the Esc
button.
Starting Data Collection
After setting the data collector options and selecting a route, you are now
ready to start data collection.
1. Once you have selected a list, you begin collecting data from the
designated point on the route. See Selecting a Route on page 80 for
information about selecting a route.
2. Connect the transducer and press READ/OK to start a measurement.
To highlight an item:
• press the UP or DOWN
ARROW key
• tap the item on the
touchscreen with the stylus